Ricoh JP735 Servisní příručka stáhnout pdf (Strana 164)

C261 8-6 SM

• Make sure that the correct end of the metal screen is overlapping. (The right side

overlaps, as viewed from the non-operation side, as shown above.)

• Secure the metal screen with filament tape.

• The 4 screws holding the drum master clamper are longer than the 12 screws

holding the metal screen, although they are similar in appearance. Be careful not

to mix them up or use the wrong screws.

• When installing the metal screen, secure the trailing edge first with the 2 screws.

Then, tighten the other screws while removing the slack from the screen. Make

sure that the gap between the drum flanges and the screen is 0.3 mm or less, as

shown above. (The two holes [A] on the trailing side are round holes and the

other holes are long holes, to allow for the removal of the slack.)

• Position the springs [B] and [C] (one each at the front and rear) as shown when

reinstalling the drum master clamper [D].

• Do not scratch the cloth screen or metal screen.

C261R906.WMF

C261R907.WMF

[A]

[B]

[C]

[D]

CÓPIA NÃO CONTROLADA

1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 173 174

Žádné komentáře

Ricoh JP735 Servisní příručka Strana 164