Ricoh FV-L030B1 Uživatelský manuál

1/32 FV-L030B1 User’s Guide Rev. 1.01 Small Cubic Type VGA CCD Monochrome PoCL Camera Link Camera FV-L030B1 User’s Guide

10/32 FV-L030B1 User’s Guide Rev. 1.01 2.2.2 Vertical Timing 2.2.2.1 Binning Full Scanning (setting 10H: 1XX10XXX, 11H: XXX0X000) 1 H =

11/32 FV-L030B1 User’s Guide Rev. 1.01 2.2.2.3 Binning 1/2 Partial Scanning (setting 10H: 1XX11XXX, 11H: XXX0X001) 1 H = 63.5556 μs, 1

12/32 FV-L030B1 User’s Guide Rev. 1.01 2.3 Data Order on the Camera Link Output DA0～DA9: 10 bit data for one pixel

13/32 FV-L030B1 User’s Guide Rev. 1.01 2.4 1 Taps Transferring Image（1X-1Y） XWYHXW-1YHX2YHX1YHTap1Sep X = 1Sep Y = 1X1YH-1X2YH-1XWYH-1XW-1YH-1

14/32 FV-L030B1 User’s Guide Rev. 1.01 3 Camera Operational Mode 3.1 Normal Mode In this mode, the images are output continuously. 3.1.1

15/32 FV-L030B1 User’s Guide Rev. 1.01 3.2 Pulse Width Trigger Mode In this “pulse width trigger mode” with positive polarity, the came

16/32 FV-L030B1 User’s Guide Rev. 1.01 3.2.2 Pulse Width Trigger Mode (Non-Reset) Note 1: The camera does NOT switch to no

17/32 FV-L030B1 User’s Guide Rev. 1.01 3.3 Edge Preset Trigger Mode In this “edge preset trigger mode”, the camera exposure starts at the ris

18/32 FV-L030B1 User’s Guide Rev. 1.01 3.3.2 Edge Preset Trigger Mode (Non-Reset) Note 1: The camera does NOT switch to no

19/32 FV-L030B1 User’s Guide Rev. 1.01 3.4 H Reset Mode Normally, video noise appears when the beginning of trigger signal is applied before

2/32 FV-L030B1 User’s Guide Rev. 1.01 Tables of Contents 1 Connector Specifications...

20/32 FV-L030B1 User’s Guide Rev. 1.01 4 Communication Protocol This camera has a communication function that enables external devises, such

21/32 FV-L030B1 User’s Guide Rev. 1.01 The description of the format is as follows. Name Descriptions SOF Start of Frame. Always set or rece

22/32 FV-L030B1 User’s Guide Rev. 1.01 【Example Code】Reading the data from the command 00H  Command to send: 02H, 00H, 00H, 01H, 00H, 03H

23/32 FV-L030B1 User’s Guide Rev. 1.01 4.4 Camera Control Command 4.4.1 Camera Command List  The data unit of the each command is 1 byte (

24/32 FV-L030B1 User’s Guide Rev. 1.01 Command No. R/W Save to EEPROM Function Initial Data Data Range 78H R/W X Test pattern selection (8b

25/32 FV-L030B1 User’s Guide Rev. 1.01 4.4.2 Descriptions of the Camera Control Commands (The underline settings are the factory default se

26/32 FV-L030B1 User’s Guide Rev. 1.01 Command No. Command Descriptions 12H: MOD3[70] [Camera function mode setting 3] Initial data: 0 Sets t

27/32 FV-L030B1 User’s Guide Rev. 1.01 Command No. Command Descriptions 20H: SVR[70] 21H: SVR[158] [Exposure time (H) of the electronic shu

28/32 FV-L030B1 User’s Guide Rev. 1.01 Command No. Command Descriptions 28H: DLY[70] 29H DLY[15...8] [Delay time for the trigger] Initial Dat

29/32 FV-L030B1 User’s Guide Rev. 1.01 Command No. Command Descriptions 78H: TESTP[70] [Test pattern selection] Initial data: TESTP[7..0] = 0

3/32 FV-L030B1 User’s Guide Rev. 1.01 1 Connector Specifications 1.1 Camera Link Connector SDR (3M) or equivalent This prod

30/32 FV-L030B1 User’s Guide Rev. 1.01 Command No. Command Descriptions A0H: PDC0[70] [Pixel defect correction mode] Initial data:

31/32 FV-L030B1 User’s Guide Rev. 1.01 Command No. Command Descriptions C5H: [70] [Look-up table (Gamma)] Initial data: [7..0] = 00H D[7..0]

32/32 FV-L030B1 User’s Guide Rev. 1.01 Revision History Rev Date Changes Note 1.00 2012/06/20  Initial Release 1.01  Updated Camer

4/32 FV-L030B1 User’s Guide Rev. 1.01 1.2 Power-I/O Connector  HR10A-7R-6PB（Hirose）or equivalent  This connector is for the power supply

5/32 FV-L030B1 User’s Guide Rev. 1.01 2 Camera Output Timing Charts 2.1 Normal Mode (Setting 10H: 1XX0XXXX) ※Clock Speed: 36.8181 MHz（N

6/32 FV-L030B1 User’s Guide Rev. 1.01 2.1.2 Vertical Timing 2.1.2.1 Normal Full Scanning (setting 10H: 1XX00XXX, 11H: XXX0X000) 1 H =

7/32 FV-L030B1 User’s Guide Rev. 1.01 2.1.2.3 1/2 Partial Scanning (setting 10H: 1XX01XXX, 11H: XXX0X001) 1 H = 63.5556 μs, 60.0544 H

8/32 FV-L030B1 User’s Guide Rev. 1.01 2.1.2.5 Variable Partial Scanning (Setting 10H: 1XX01XXX, 11H: XXX0X111)

9/32 FV-L030B1 User’s Guide Rev. 1.01 2.2 Binning Mode (setting 10H: 1XX1XXXX) Binning Full Scanning Binning Partial Full Scanning Bin