Ricoh 917 Provozní pokyny stáhnout pdf (Strana 80)

Adding Paper and Replacing Toner

F Push the metal plate down, and then square the paper and place it in the

tray.

Do not stack paper over the limit mark.

G While pressing the release levers, push in the side and end fences until they

are flush against the paper's edges.

H Push the paper tray in until it stops.

Note

❒ When setting small quantities of copy paper, be careful not to squeeze in

the side fence too much. Paper might not feed in properly if the side fence

is too tight against the paper's edge.

❒ Be sure to set the correct size, otherwise a paper jam might occur.

❒ Load paper so that the paper touches the right side of the tray. Otherwise

misfeeds might occur.

ASS004S

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 99 100

Žádné komentáře

Ricoh 917 Provozní pokyny Strana 80