Ricoh Type 480 Uživatelský manuál stáhnout pdf (Strana 103)

JOB EDITOR

• Border:

If you want a white border around the drawing, activate the

field "On" and enter the required spacing for all side

borders. The maximum border is 499, 99 mm (19,68 inch,

11811 Pixel). The current dimensional units are given in the

status bar at the bottom of the monitor.

• Media Source:

Here you can select the trays in which the rolls with the

different Printing materials (plain paper, film, etc.) are

located. They can also have varying widths.

If you select the "Auto" setting, the plotter chooses the media

source, which matches the format size of the drawing.

Should this input tray be empty, the plotter uses the tray (roll)

with the next largest format. The option "bypass tray" can be

used for putting in a special medium like thick or colored

paper. The job will be marked blue in the job list.

The remaining procedure is described on page 83.

If you want to cancel this job in the meantime, select the job

in the job list and hit with right mousebutton (context menu)

the command "cancel job".

• Invert:

If you activate this option, the drawing is inverted, black and

white colors are swapped.

"Default Additional" tab

Use the card "Default Additional" to enter details for stamping

and for HPGL and Calcomp pens.

The stamp editor and the pen settings (Calcomp, HPGL) are

each explained in their own chapter. Please read the separate

"Stamp editor" section at the end of this Chapter from Page 110

ff. and the separate chapter on "Pen settings " from Page 117 ff.

RW-480 PLOTBASE 103

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 233 234

Žádné komentáře

Ricoh Type 480 Uživatelský manuál Strana 103