Ricoh Type 480 Uživatelský manuál stáhnout pdf (Strana 112)

JOB EDITOR

that you have saved previously (read the following chapter

"Stamp Configurations") from the file selection. Now save

this configuration by clicking on the button with the same

name; i.e. "Save". This configuration is now saved under

the marked stamp name in the "Select Stamp" window.

4. You can produce as many stamps as you wish for a

drawing. If you now also want to configure an additional

new stamp, click on the following button:

5. Enter a name and set the desired configurations, as

already described under Step 3.

Stamp Configurations

The stamp settings are usually saved for specific entries. This

means that these settings only apply for one entry or a limited

number of entries. However, you can also save a stamp

configuration in its own "Stamp File". It can then be used at any

time for producing a new stamp, which you would like to use for

other entries.

The stamp files have the file extension [*.stp] and it is advisable

that this extension is always retained.

Should you want to start the configuration, you must use the

"Open" button. The "Open", "Save [as]" or overwrite old stamp

files steps are the same as those used in general file

management.

Edit or delete stamp

If you want to make changes to the stamp configurations

produced, first click on the correct stamp in the "Select stamp"

window and then change the settings. If you now change to

another stamp or close the window by clicking on "OK", all the

settings are saved.

To delete a stamp, first mark it and then delete it by clicking on

the following button:

RW-480 PLOTBASE 112

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 233 234

Žádné komentáře

Ricoh Type 480 Uživatelský manuál Strana 112