Ricoh Type 480 Uživatelský manuál stáhnout pdf (Strana 111)

JOB EDITOR

by using the tools in the "View" toolbar. These have already

been explained on Page 43.

Stamp editor

You can define as many stamps as you like per drawing. The

stamp settings can be altered on two levels. To configure a

stamp for an individual entry, select the "Additional" tab under

"Entry". Now click on the "Settings" button under "Stamp". The

same button can be find in the "Defaults" area on the "Default

Additionals " tab. The settings in the "Defaults" area are basic

settings, in which the following must always be noted:

Note: The changed settings on the card "Default"

always only affect new entries. Entries already included

in a job retain their settings.

In stamp editor you have two tabs in which you can alter

settings. These are the "Settings" and "Data" tabs.

Make stamp

This chapter describes how you can name and save new

stamps.

Proceed as follows to configure a new stamp:

1. The first stamp entry is preliminarily named "000". Click on

the following symbol to edit the stamp name:

2. You can now delete the existing name entry and enter your

own name for the first stamp.

3. You can now either enter your own settings for the stamps,

as described in the following chapters or use an existing

stamp configuration. To do the latter, click on the "Open"

button under "Configurations". Now select a configuration

RW-480 PLOTBASE 111

1 2 ... 106 107 108 109 110 111 112 113 114 115 116 ... 233 234

Žádné komentáře

Ricoh Type 480 Uživatelský manuál Strana 111